Setting up the exhaust fan for your CO2 laser is crucial for maintaining a clean and safe working environment. This guide explains the steps to correctly install and connect the exhaust fan to your laser.
Step-by-Step Instructions
-
Identify Exhaust Fan Ports
- The exhaust fan has two ports: one on the side in the middle of the fan (inlet) and the other on the front (outlet).
-
Attach the Inlet Hose
- Start with the port opposite the motor (inlet). Grab one of the supplied flex hoses.
- Place the hose clamp ring around the hose before attaching it to the inlet port of the fan.
- Secure the hose on the inlet port by tightening the hose clamp.
-
Connect to the Laser's Exhaust Port
- Take the other end of the same hose and attach it to the exhaust port located on the back of the laser, just above the chiller.
- Work the flex hose over the port and tighten the hose clamp to secure it.
-
Attach the Outlet Hose
- Grab the other supplied hose and attach it to the front port of the exhaust fan.
-
Vent the Open Hose
- Ensure the open end of the hose is vented to the outside. Your exhaust setup is now complete and ready for use.
Conclusion
Proper installation of the exhaust fan ensures efficient removal of fumes and particulates, maintaining a clean and safe working environment. Follow these steps to set up your exhaust fan correctly. For further assistance, refer to Lightburn documentation or support channels. Happy engraving!