Lightburn For Gantry (Co2,RF)
      Back to home
      1. SA Laser Knowledge Base
      2. Lightburn
      3. Lightburn For Gantry (Co2,RF)

      Finding and Connecting Your Laser in Lightburn for CO2 Lasers

      This guide explains how to connect your CO2 laser to Lightburn using the "Find My Laser" feature. This ensures your software is correctly linked to your laser machine for optimal operation.

      Step-by-Step Process

      1. Preparation

        • Ensure Lightburn is downloaded and installed on your computer.
        • Open Lightburn software. If continuing from a previous setup video, this screen should already be open.
        • Make sure your USB cable is connected to both the computer and the laser.
        • Ensure your laser machine is turned on.

      2. Finding Your Laser

        • Click on Find My Laser in Lightburn.
        • A window will pop up, prompting you to ensure the device is connected via USB and turned on. Click Next.

      3. Scanning for Devices

        • Lightburn will scan for new devices, searching for the communication code to the controller card inside your laser.
        • Once detected, your laser’s model (e.g., Ruida 6445G) and workspace dimensions will appear.

      4. Adding the Device

        • Select the detected device from the options provided.
        • Click Add Device.

      5. Naming Your Laser

        • Enter a name for your laser (e.g., "Big Green Machine").
        • The name helps identify the machine, especially if you use Lightburn with multiple machines.

      6. Setting Up the Workspace

        • Confirm the X and Y axis lengths (workspace dimensions).
        • Click Next.

      7. Setting the Origin

        • Set the origin of your laser (e.g., right rear, where the home switches are located).
        • Click Next.

      8. Finalizing the Setup

        • Review the setup summary: machine name, workspace dimensions, and origin.
        • Click Finish to complete the setup.

      Verification

      • Lightburn will display the connected laser’s workspace dimensions.
      • The status under the laser window should read "Ready," indicating the machine is connected and ready to use.
      • If multiple lasers are connected, select the desired machine from the device bar.

      Conclusion

      Your laser is now connected to Lightburn and ready for use. This guide has walked you through the steps to ensure proper communication between your computer and laser machine. For further assistance, refer to Lightburn documentation or support channels. Happy engraving!