Razor Series
      Back to home
      1. SA Laser Knowledge Base
      2. Co2 Lasers
      3. Razor Series

      Stack Light Setup for CO2 Lasers

      The stack light on your CO2 laser provides visual indicators of the machine's status. This guide explains how to properly set up the stack light after unboxing your laser.

      Step-by-Step Instructions

      1. Locate the Stack Light

        • During shipping, the stack light will be stowed away to prevent damage.

      2. Remove the Mounting Screw

        • Use the supplied Phillips head screwdriver to remove the mounting screw that secures the stack light in its stowed position.

      3. Raise the Stack Light

        • Gently raise the stack light into the correct operating position.

      4. Reattach the Mounting Screw

        • Once the stack light is in the correct position, reattach the Phillips head screw to secure it.

      5. Final Check

        • Ensure the stack light is securely fastened and ready for operation.

      Conclusion

      Setting up the stack light correctly ensures you can easily monitor the status of your CO2 laser. Follow these steps to install your stack light properly. For further assistance, refer to Lightburn documentation or support channels. Happy engraving!